One ZPU anti-aircraft gun in 12mm or 1:144 scale.
3 different variants are available:
ZPU-1
ZPU-2
ZPU-4
Please read the assembly instructions below:
Warning: At this scale these models are small and therefore delicate and harder to assemble than at the larger scales
ZPU-1. This gun comes in 2 parts. The barrel simply needs to be glued in position at your preferred angle
ZPU-2. This gun comes in 4 parts. The gun barrel part is a push fit into the body of the gun, it may be glued in position or left free to move. The wheels are separate and must be glued in place. The wheels can be placed in either the travelling or deployed position (pictures show the gun deployed, the mudguards should be uppermost in the travelling position).
ZPU-4. This gun comes in 5 parts. Take care removing the support material. The gun barrel parts should be glued together first. Once glued together the gun barrels can be fitted into the body of the gun (note the correct orientation in the pictures). Finally the upper part of the gun body should be glued in place to completely enclose the gun barrel parts. It is recommended to glue the gun body onto the carriage as the spigot is quite short.
Due to the small size of these models pictures shown are for 28mm PLA models
Printed in high resolution resin
All models supplied unpainted, unbased and without crew (figures)
3D printed to order
